-
Legacy Member
Receiver stamp 1903/A3?
My buddy inherited a 1903/A3 with an RA barrel 12-43 but the receiver just has U.S. and the serial number 48xxxx. I am trying to help ID the manufacturer. Any ideas?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
05-26-2020 12:36 AM
# ADS
Friends and Sponsors
-
Legacy Member
There doesn't appear to be enough digits in ser no.
-
-
-
Advisory Panel
Pics of all of this will help immensely.
-
-
Legacy Member
If the receiver has 6 numbers than it is most likely a M1903 Springfield. It was not uncommon to use a M1903A3 barrel if it was sportirized. Is the receiver drilled and tapped?
If the barrel has the rear sight base it could be a SA receiver with a bubba barrel where someone welded the front part of a 1903A3 barrel to a 1903 barrel.
If the only markings are US and the serial number someone could have removed the markings and re stamped it. Pictures will be of a great help.
Last edited by mark1; 05-26-2020 at 04:42 PM.
-
-
Advisory Panel
If the serial number has seven digits, then it's Smith-Corona receiver. That, of course, assumes whoever removed the markings didn't make up and re-stamp a serial number.
J.B.
-
-
Advisory Panel
Remington? Smith Corona? or National Ord, Santa Fe Arms?
-
-
Legacy Member
Pictures of rifle
Ok, I just picked up the rifle so I could provide pictures. In looking at the rifle I noticed a few things; missing manufacturers stamp, lack of a gas port on the receiver, smoothed edges on top left of receiver, follower looks like it has been replaced to allow bolt to close regardless of cut-off position, bolt has some interesting stamps, last digit of serial number is not in line with rest of numbers and is partially covered by top of hand guard. Hopefully I've provide a good starting point. Thanks everyone. Michael
-
-
Advisory Panel
Might be a good candidate for a complete strip and photo heavy thread to help solve this. Things don't look right, for sure.
-
-
Legacy Member
-
-
Advisory Panel
Looks like the barrel ring was polished clean and hand stamped while the receiver looks to have been cold blued after...
-