Milling #4 receiver for 762 mag, info needed

[Lee Enfield]

Thanks Lee Enfield,

I’m using an Enfield 7.62 mag and I’ve heard/read the feed lips could get bent if the relief cuts aren’t made.
I have the receiver off the barrel and a machinist buddy willing to do it so I’m going to take the extra precaution since the mag was NOT cheap!!

There is a copy of the drawing in "An Armourer's Perspective" and it has been posted on this site several times.

https://www.milsurps.com/content.php...-Peter-Laidler)

Lee Enfield Service Repair