When it really happens: SHTF...

[CINDERS]

Ovidio just be sure with your H/G loads (Infact any reloads) your above 50% case capacity that way if you do muck up and double charge a round the case will over flow.
I have a pic somewhere of an 44Mag S&W stainless with the back strap blown clean off and about half the cyliner blown off as well from a user who said to the cops handing it in he was shooting reloads.

As far as Covid goes Sydney has had new cases eastern states are still struggling with this thing the politicians are plucking money from goodness knows where to keep stuff going but none have stood up and are taking a pay cut Why The Frig! would they.
Rumours are abounding about our states locked boarder and it is a pre-empt for possible cessation from the rest of Australia as this has been twice tried before and defeated as the country relies on our minerals and gas to keep the engine running.
I voted twice for sucession but as stated it never occured we will see it looks like down the track, our premier wants to keep it shut till possibly April or June 2021.
Then as we see all over the planet with Covid we also have the knuckle draggers and evolution rejects here that defy logic and flaunt the law wasting valuable police and armed services time with their antics and anti-mask rallies.

Look guys who knows where this is gunna end I fear a global collapse of the monitary system leading to a depression worse than that of the 1930's and after WWII we may then find ourselves in a barter system for food and water etc.
We have no gunpowder down here in the S.W nor projectiles nor primers infact I heard a story they are buying up over east and shipping it back to the USA nothing would surprise me.
My wife and I hedged for a few years we have lotsa barrels, pills, primers, powder, cases for all our rifles so are comfortable shooting for about the next 4 years straight by which time all will be right again.
Look after yourselves and family try to avoid the knuckle draggers when you are out, but if you end up with a hood ornament then the gene pool will be a better place...........Cheers.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Ovidio]

Hi Ron, I check each load optically.
When they're on the plate, I also check them to see if the level of powder ist the same in all the brass.
Nothing is automated yet, so the level of safety is still very high.Attachment 111518