So last weekend I made up 50 rounds of necksized once fired ggg cases, cci bench primers, 44grns N140, 150 gen SMK FMJ, with OAL 2.70”

I was zeroing a new sight to rifle and while I was at the range office I grabbed a few GGG 147grn. Down at the zero range I decide to dial it in with the GGG factory and then confirm where things were with my hand loads. The end point of the GGG was two rounds though a single hole (no great feat given the ~71’ range). Now for my confirmational shots with the hand loads, four holes a tad lower close but by no mains touching.

Rather disgusted I loaded a could more GGG and while the single hole enlarged or was still very much one round hole.

Upset I pulled out some 1980 144grn IMI, 4 rounds in a single hole a little lower and right.

So far when ever I've compared my 303 hand laods to PPU mine have very much proved superior. Is PPU 303 setting the bar for seasonal handlaoding low, is my 762 recipe way out, or do j really need to brush up my reloading game?

Any thoughts welcome!!!