Please help identify this bayonet

[A34]

Thanks for the advice guys, that worked pretty well. The grip hole is countersunk, so the nut only goes down so far. Any suggestions on a poor man's way to countersink the nut to fit better? Currently it sticks out some, which i can live with, but would like a flush fit. Of course, finding the correct screw/nut set would be even better!

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

Any suggestions on a poor man's way to countersink the nut to fit better?

Lay a newish mill bastard file flat and carefully lap the nut by hand lengthwise on the file until it drops sub surface. Careful not to press too hard on one side or it'll be at an angle. Of course the bottom of the nut is on the file.