-
FREE MEMBER
NO Posting or PM's Allowed
O3-A3 front sight A marked
My O3-A3 hits about 12 inches high at 135 yards with a front sight marked A . Is there a front sight that would drop the point of impact and a source for one . Thanks
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
06-24-2021 01:39 PM
# ADS
Friends and Sponsors
-
Legacy Member
I can't do the math but there are other heights. See this at CMP Forums
http://forums.thecmp.org/showthread.php?t=54746
After thinking a bit, you have the tallest without an aftermarket part (is there one?). Use the rear sight to change the sight picture. Maybe use 6 oclock hold? Where is your point of aim? If dead center, then aim lower, at what's know as 6 oclock, bottom of the target.
Is the rear sight at it's lowest point, all the way forward? (if I remember correctly)
Are you adjusting your rear sight for elevation? See this
http://forums.thecmp.org/archive/ind.../t-168544.html
Last, is the ammunition correct for use in the 19O3A3?
https://www.quora.com/What-is-the-co...ngfield-1903A3
Last edited by daengmei; 07-30-2021 at 09:41 PM.
-
-