-
Legacy Member
need remington M1917 lower handguard
anyone have a remington M1917 lower handguard to sell?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
11-09-2021 12:57 AM
# ADS
Friends and Sponsors
-
Contributing Member
-
-
-
Legacy Member
Thanks! I saw that, but is the pic a Remington, and how can I be sure they send me a Remington if the have Eddys and Wins? I didnt see any mention of the manufacturer. I thought the groove looked short so I thought the pic was of a Winchester.
-
-
Legacy Member
No manufacturer from WWI made these. They are replacements made for WWII refurbs. I have a set on my P14 and they're excellent. The only real noticeable difference is the rivets are made of iron instead of brass like the originals.
-
-
Legacy Member
-
-
Legacy Member
Caution. I purchased one of these from Apex a few months ago and it would not fit over the barrel of my 17 Eddystone. The barrel channel in the guard had not been routed large enough to fit over the barrel. They are also not as tall as an as issued 17 guard. I phoned the company asking if I could exchange it for another one and was told that they would all be the same.
In the attached is an as issued 17 guard on the left and the Apex reproduction on the right.
The guard on the left was purchased from Numrich and fits perfectly. It looks to be authentic NOS WW1 issue. It was more expensive than Apex but worth it.
-
-
Legacy Member
-
-
Legacy Member
Originally Posted by
MOS-45
Caution. I purchased one of these from Apex a few months ago and it would not fit over the barrel of my 17 Eddystone. The barrel channel in the guard had not been routed large enough to fit over the barrel. They are also not as tall as an as issued 17 guard. I phoned the company asking if I could exchange it for another one and was told that they would all be the same.
In the attached is an as issued 17 guard on the left and the Apex reproduction on the right.
The difference is because the barrel channel routing is larger on the M-1917 than the P-14. If you looked at the underside of a factory handguard for each model, it's very obvious, especially near the chamber area. One look at the barrel profiles of each rifle also tells the story. You could route out the smaller P-14 handguard for clearance if you have no other option.
-
Thank You to M94/14 For This Useful Post:
-
Legacy Member
Good to see the reason why they didnt fit. Thanks for sharing!
-