-
Legacy Member
No4 T Rear Pad Stake Marks
Hi all,
Just wondering if it's usual for a No4 T to have no stake marks in the two rear pad screw heads?
I'm looking at a rifle which has all the correct markings except the rear scope pad is missing the stake marks. The front pads all have one stake per screw head just wondering why the rear wouldn't have any stake marks.
Thanks
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
11-10-2021 05:40 AM
# ADS
Friends and Sponsors
-
The pad staking didn't really start until post WW2, so if the rifle was sold off from service earlyish it would not have been done. I've owned quite a few with non-staked rear pads. If you're wanting to determine its authenticity perhaps you could get some photo's & post them up here? It is particularly helpful to get butt socket markings & the area of the two body pads without the scope & bracket fitted.
In fact, I've often wondered if many rear pads were intentionally not staked as the rear pad is not under the same stresses as the front one, & staking may cause minor damage that would impair the mating up of the bracket against the dovetail on the pad. Many were done of course, but it would have required more care (than doing the front pad).
Last edited by Roger Payne; 11-10-2021 at 06:43 AM.
-
-
-
Even soldering the pads on was not done for some time until the screws started backing out and shearing off.
There were a number of heated letters back and forth on this between Canada and the UK.
-
Thank You to Warren For This Useful Post:
-
Legacy Member
Thanks for the replies. Appreciate the information!
I've attached a couple of pictures of the front and rear pads...sorry about the quality.
I will see if I can get some better pictures.
-
-
Difficult to be dogmatic with the limited views but from what I can see it looks ok to me.
Last edited by Roger Payne; 11-14-2021 at 06:14 PM.
Reason: typo
-
-
Advisory Panel
Originally Posted by
Spakfilla
Thanks for the replies. Appreciate the information!
I've attached a couple of pictures of the front and rear pads...sorry about the quality.
I will see if I can get some better pictures.
Looks entirely original to me. One can see that staking the rear pad screws really depended on where the slots happened to align, as in some positions there was really nothing to stake into without risking deforming the bearing surfaces for the bracket.
Originally Posted by
Warren
Even soldering the pads on was not done for some time until the screws started backing out and shearing off.
There were a number of heated letters back and forth on this between
Canada and the
UK.
What do they say Warren? Was it in the original specifications or conveniently omitted?
Last edited by Surpmil; 11-16-2021 at 10:51 AM.
Reason: Typo
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same.
-
-
Contributing Member
Staking
My T's rear screws are staked whether this was done because it was involved in the pad trials it was used for as the T's seemed to have suffered at one point with the front pads working loose.
As can be seen there are plenty of staking's on the front pad screws.
(P.L & Skennertons book on the T ~ Pg.48 T-38752/16684 - A.K & S, Dowelled bush and screw trials.)
-