1899 Carbine 348xxx

[butlersrangers]

'METT-T' - Your Krag, #348676, was manufactured as a U.S. model 1899 carbine around September 1901.
You have a correct model 1901 carbine rear-sight and the handguard with sight-protecting 'hump'. Initially, your carbine likely had the same handguard as used on the model 1898 infantry rifles, with the 1901 'Buffington' designed sight.
The carbine handguard with the 'lump' was approved around April 1902.

Lots of model 1899 carbines were updated with the 'sight-protecting handguard' when they were returned to the Armory for 'refurbishing'.
During Armory/Arsenal repair or rebuilding of a Krag, new replacement stocks were often put on. New replacement stocks would not have an 'acceptance cartouche' stamped on them.

The stock would receive the 'circled P' stamp at the Armory or Arsenal, indicating the rebuilt arm was 'proofed' and function tested.

Your Krag front-sight base appears to have been put on the barrel by a gunsmith or hobbyist, after it entered private hands.
The brazing is very crude and the muzzle-crown does not look correct.

It is possible that your carbine had a poor bore when it got into civilian hands. A good rifle barrel may have been cut to 22" length and the front-sight was salvage and brazed on.
Another possibility is the original carbine barrel could have had its issue sight removed and a commercial 'banded' sight was put on. At a later time, someone may have brazed on a salvaged Krag base in a restoration effort.

There were about 32 major operations in the manufacture of a Krag barrel. Springfield Armory machined a dovetail across the barrel-blank and bronze-brazed a small block of steel in the dovetail, about 1/2 way into the production of the barrel.

This 'lug' was used to locate many of the following machine operations on the barrel. Eventually the lug was shaped and slotted to become the finished front-sight base. The dovetail and brazing seam become nearly invisible.

Your front-sight attachment is not Springfield Armory work.

Your front sight-blade may have a faint small "C". When taken out of its base, the 1899 carbine blade is .355" tall. A 'loose' 1898 rifle blade is .413" tall.

Attached is a copy of your front-sight photo. I have marked what I see as a possible "C" stamp and also the crude brazing.

Also attached are photos showing a correct front sight attachment and a closeup of the carbine blade.

Attachment 122308