My 2nd Krag

[butlersrangers]

Make sure that the fine rivet, that holds the follower to the carrier-arm, is totally flush and not sticking out a bit and dragging.

There were changes to the follower and carrier-arm during model 1898 Krag production to improve feeding of the last round.

Not all of these assemblies are the same.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[ssgross]

Make sure that the fine rivet, that holds the follower to the carrier-arm, is totally flush and not sticking out a bit and dragging.

That was my first thought. And the geometry of the tip is certainly different.

There were changes to the follower and carrier-arm during model 1898 Krag production to improve feeding of the last round.
Not all of these assemblies are the same.

I found that out the hard way! Good thing they are still cheap enough grab a couple. I re-worked this one good enough to get to the range this week or next.