-
Contributing Member
5 Nov 2023 Garand Picture of the Day - this is a stretch but there is one there
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
He is no fool who gives what he cannot keep to gain that which he cannot lose
There are no great men, only great challenges that ordinary men are forced by circumstances to meet.
-
The Following 14 Members Say Thank You to Mark in Rochester For This Useful Post:
25-5,
42rocker,
Bill Hollinger,
Bob Womack,
CINDERS,
ed skeels,
fboyj,
frankderrico,
Jonzie,
lgr1613,
Low & Slow,
Ovidio,
RAM1ALASKA,
Zeke55
-
11-03-2023 09:40 PM
# ADS
Friends and Sponsors
-
Advisory Panel
I've been right where they are, "Let's see...fails to feed"...belt holding pawl spring.
-
The Following 3 Members Say Thank You to browningautorifle For This Useful Post:
-
-
Contributing Member
That’s a biiiiig Garand
34a cp., btg. Susa, 3° rgt. Alpini
-
Thank You to Ovidio For This Useful Post:
-
Legacy Member
Another fun job is building one from parts. Before I was done, I believe that I had bought parts from over 10 different folks/companies.
Did buy a Grand barrel at a shoot a few days ago.
Later 42rocker
-
-
Legacy Member
BMG 50 cal extractor
Here is a 50 cal BMG extractor, note the inspector RS in box - same district as Winchester
-
-
Contributing Member
Timing
I always had a terrible time keeping that .50 timed right...
Real men measure once and cut.
-
Thank You to Bob Seijas For This Useful Post:
-
Advisory Panel
keeping that .50 timed right
Now they're done complete and you just quick change the barrel. That changed for us in '96. FN came out with them. Fit the barrels to the gun and use the FN ammo and you have no problems.
-
PM
Originally Posted by 
