-
Contributing Member
Barrel welded to receiver on No.4
An acquaintance asked me to check out his father's "Lee Enfield" rifle that hasn't been shot in almost 40 years and I was surprised upon first look to see the barrel appears to be welded to the receiver on his scrubbed No.4 Mk I. He wants to start shooting it so I offered to check it for headspace, bolt lug engagement, and barrel condition. The #1 bolthead closes on a field gauge but the lugs engage evenly. The bore is dirty but the rifling is a 7 out of 10. However, I am greatly concerned about the barrel welded to the receiver and in an abundance of caution I'm going to tell him to not ever shoot the rifle again. I'm interested in hearing if anyone else has seen a N0.4 barrel welded to the receiver and the possible woes it could be hiding.
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
02-26-2024 05:01 PM
# ADS
Friends and Sponsors
-
Advisory Panel
I'm going to bet you a buck...it's a No1Mk3 barrel scabbed on there and welded to hold it. You'll find a #1Mk3 barrel will screw on but ends up with sights at BDC. I think that's what's happened here. What sights are on the front?
If it's a #4 barrel then it's still suspect that it wouldn't tighten up correctly and was welded to end their woes.
Looks like it was blued with a wool sock...
-
The Following 2 Members Say Thank You to browningautorifle For This Useful Post:
-
-
Advisory Panel
Someone sure had a go at customizing it.
I would not be comfortable shooting it.
-
Thank You to tiriaq For This Useful Post:
-
Legacy Member
I'm not even comfortable looking at it.
-
The Following 4 Members Say Thank You to BVZ24 For This Useful Post:
-
Advisory Panel
Looks like it got too close to a 220v 5hp flap wheel.
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same.
-
Thank You to Surpmil For This Useful Post:
-
Advisory Panel
Someone has turned it into a "small ring" enfield by reducing the receiver ring to the torque shoulder diameter of the barrel.
There is not much material left - I would recommend scrapping it for parts.
Retain the receiver as a curio is it survives disassembly.
-
Thank You to Lee Enfield For This Useful Post:
-
Contributing Member
Originally Posted by
Lee Enfield
Someone has turned it into a "small ring" enfield by reducing the receiver ring to the torque shoulder diameter of the barrel.
There is not much material left - I would recommend scrapping it for parts.
Retain the receiver as a curio is it survives disassembly.
Fortunately my friend has accepted the fact that the rifle should be retired and although there might be a Lee Enfield oddity collector out there interested in such a rifle he wants to hold onto it as a keepsake as it was his father's rifle.
-
-
Contributing Member
Certainly a curo, I would at least deactivate it to ensure no-one tries to shoot it in the future, it's got shoulder launched hand grenade written all over it...
Makes you shudder to think of anyone pulling the trigger on that...
.303, helping Englishmen express their feelings since 1889
-
Thank You to mrclark303 For This Useful Post:
-
Advisory Panel
Originally Posted by
mrclark303
Makes you shudder to think of anyone pulling the trigger on that...
I'll bet it was used successfully for years.
-
Thank You to browningautorifle For This Useful Post:
PM
