-
FREE MEMBER
NO Posting or PM's Allowed
Lyman 48C parts diagram
Does anyone have a parts diagram or schematic of the Lyman 48C sight that was mounted on the M1922 series rifles? The sight on a friend's M1922 MI has no clicks on the elevation slide. Figured out the spring and detent ball are missing, but not sure what else.
Bill
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
07-17-2009 09:24 PM
# ADS
Friends and Sponsors
-
Legacy Member
barkerwc4362:
While it's not really a parts diagram, there is a breakdown of the Lyman 48C rear sight in Brophy.
HTH
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
I saw the info on pages 473 - 475. I was hoping someone had a Lyman parts breakdown so we could figure out what parts are missing from the sight. Thanks.
Bill
-
FREE MEMBER
NO Posting or PM's Allowed
Its not a very complicated device. What exactly is your question?
-
FREE MEMBER
NO Posting or PM's Allowed
A friend's 48C is missing some parts on the elevation slide. The slide can be moved down by turning the screw, but does not move when the screw is moved upward. There are also no clicks when the elevation screw is turned in either direction. Apparently someone took it apart in the past and lost some of the internal parts on the elevation part of the slide. If I had a exploded view or parts diagram I could identify which parts are missing.
Bill
-
FREE MEMBER
NO Posting or PM's Allowed
This a diagram of a 48WH used on the Winchester model 70 National Match. It should be the basic design:
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks, I hope that with this we can figure out what is missing.
Bill