-
Legacy Member
.30 Cal. Carbine brass processor
Have approx. 5000 once and multi fired Carbine brass cases. Appox half is deprimed, sized, and mouth flarred....but need to be trimmed to 1.280
The other half is once fired just polished. Need to be deprimed, sized, and mouth flarred, then trimmed to 1.280
Looking for someone to process this brass to make it load ready on a progressive machine.
I just don't have the time anymore to prep these cases. If you do, just email me a quote to process per 1000 or for the lot. I will pay shipping both ways.
Anthony@m1garand.com or 631 205 1299 Thanks! APJ
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
08-09-2009 08:39 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
I believe that you should trim the brass before flaring the neck? This is how I do it but I could be wrong. Good luck with finding someone to do this for you
-