Fulton is currently out of the commercial replacement barrels but, they have some de-mills. These barrels have been chopped off right behind the front sight and come with no parts (sight, piston, nut).
I ordered one and was able to recover an "honest" 16.25". I then made a false muzzle and brazed that on the end. I then machined it to the correct profile and length for my carbine. I must admit that I have yet to finish headspacing and test firing it but, confidence is high. Understand that these are brand new, never been fired barrels. They will need to be properly installed and headspaced before use. They (Fulton)advertise them as Winchesters and the one I received was.
There are other de-mills out there and I beleive that is what the ones on Gunbroker with FAL flash suppressors are made from. Reason being is that some of those are sheared very short.

Bottom line is that I feel confident that my "new" barrel will shoot for many years to come and my total cost???? $24.95 + shipping.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.