I have a very used Garandicon receiver SN 2435XXX

Not an actual picture. ImageShack - Online Photo and Video Hosting

Its hard to explain but part of the op rod track appears to be bent, Towards the end where the locking area for the bolt lugs are it appears to be bent in/up.

I'm sorry If I'm not explaining it well however, My other 2 receivers will freely slide the bolt all the way into lock (without a barrrel) This one the bolt moves into the red area refuses to move forward, the rest of the receiver appears to be within spec.

Is there anything I can do to salvage this? (Bend it back)?

I'm aware this area is under 50K psi when a round is going off.

Thank you.

Any idea what could of caused this?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.