Hi Guy's

Just in process of repairing a No1 Mk111 cut-off. It appears that the retaining screw has been stripped or drilled out by the previous owner, quite how or why I have no idea. I've just purchased a replacement screw but of course the hole is now slightly bigger than the screw and of course has no thread so the hole will probably need to be doweled and re tapped to accept this new screw to enable the cut-off to work again.

My question is... does anyone know the BA thread size for the Cut-off screw? or are Enfield thread sizes a non standard thread. Any ideas or tips how best to repair this would be much appreciated.


Regards

Mac
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.