Inspect those used revolvers carefully.

[WarPig1976]

Picked this up on my travels today. It's a S&W M&P 65-1 in .357 mag.
Attachment 62212
Attachment 62213
Checked it over an everything seemed fine, the cylinder gap was a tad wide but I could shim that. About to hand it back and start the paperwork and I noticed this
Attachment 62210
And this...
Attachment 62211
See what I see? Well, told the the guy to hold the phone and I did the hammer thumb pressure test and...CLICK. Well, well,well, Bubba did a trigger job. Since I'm not the average gun buyer I knew I could fix all the issues and about how much it will cost. I had a talk with the owner and he took $150 off. Glad I figured it had problems at the counter where it saved me a few bucks and not while at home. Now for a new hammer and possibly trigger.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.