Sten barrel line drawing.

[browningautorifle]

I have to make up a MK2 STEN barrel dummy. I intend to turn it out of solid stock and drill an inch in to both ends for simulation of bore and chamber. The barrel is to be mailed to the buyer and installed into a cock and click dewat so I have to complete it and it needs to fit.

Therefore, does anyone have a line drawing of a STEN barrel that I can work from? I have PL's book but there's no line drawings, everything available on line gives me NOT what I need.

Does anyone have a simple machinist drawing? Inch drawing? Micrometer measurements?

If it's a PDF then message me and we can correspond by email.

Thanks in advance...

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.