-
Legacy Member
Charlie, my two peep sights are just like the last one on the bottom of post #10
-
-
11-19-2020 09:05 PM
# ADS
Friends and Sponsors
-
These sights are darn small - the leaf even smaller. A small difference in the camera angle can make a big difference when looking at a part that size. Here are (2) pics of a "believed real" sight - the short leaf is offset from the pin by more than I would have expected. - Bob
-
-
-
Legacy Member
Carbine parts value depends on the maker and when it was made. There are several "types" too. Gunparts wants $28.75 for a 1st issue, repro 'L' rear sight, $20 for a complete, 'late issue', stamped, rear sight. $45.75 for a "middle issue", milled repro, sight. $52 for a milled, Type II without an aperture and $36.50 for a repro Milled Type II without an aperture.
No apertures or 'flip' sights listed.
Spelling and Grammar count!
-
-
Originally Posted by
Sunray
Gunparts
All Junk !
Charlie-Painter777
A Country Has No Greater Responsibility Than To Care For Those Who Served...
-
-
Advisory Panel
We weren't talking about repro stuff anyway...
-
-
Contributing Member
I found this Rear Sight a long time ago and was always looking to see if I ever would come across another one with the L having the mark BR on it. Is this marking from Jasper Blackburn Co ?
Thanks to Bob for letting me know there was one posted. I have never tried to sell it because I never knew if it was fake or not.
-
-
Legacy Member
larger outside diameter of peep
Frank, your BR coded peep is just like mine, notice the larger outside diameter.
So, are they original ?
Robert
-
-
Contributing Member
Originally Posted by
RCS
Frank, your BR coded peep is just like mine, notice the larger outside diameter.
So, are they original ?
Robert
Robert, I have a couple Originals Flip Sights and I will look at the differences between them. I was told both that this one was Original and early iirc maybe later and a couple of people said it was fake but they still offered to buy it from me and say they could use it for Re-enactments. I have this Sight so I can take more picture and show it. I'm just a little busy at the moment. Let me know if you want to see all sides and the thickness compared to others.
-
-
Legacy Member
Frank, no rush, maybe a photo of the side profile and bottom
Thannks, Robert
-
-
Originally Posted by
imntxs554
Is this marking from Jasper Blackburn Co ?
That company made 'em for Rock-Ola. - Bob
-
Thank You to USGI For This Useful Post: