C7CT

[Gil Boyd]

The true factual basis of the photo, was, it was taken in Basra, of two filthy shop owners who thought they were fit enough where bets were taken on who would win a run around the block

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Lee Enfield]

I wish we could import components and complete rifles from Colt Canada. Unfortunately, there is an agreement between Colt Hartford and Colt Canada that doesn't allow distributors to export them. The factories do exchange parts from time to time for Government production and sales. It may just be my imagination but I find the quality of the Canadian produced parts to be of a higher standard than parts produced in Hartford. Many of which are most likely contracted outside of the factory.

Hey Brian, it's even a little more difficult than that, Colt Canada had to get US State Department permission to sell the Semi Auto ar15 rifles (and parts) to Canadian civilians.

It held the civilian sales program back by at least 6 months.

---------- Post added at 11:45 AM ---------- Previous post was at 11:37 AM ----------

Gil,
Thanks for responding and sending me to some good info. I've attached some photos of what I'm looking for. Specifically, I'm looking for the free float handguard and scope mount (2nd and 3rd photos)as seen in the photos. Also, which brand suppressor is used. Manufacturer names and/or sources for locating these parts would be very helpful.

The free float tube is VERY '"90s," aluminum. The Hogue tube if you could find one without the overmold would be identical.
here is a close copy:
AR15 RIFLE LENGTH FREE FLOAT TUBE

AR-15/M-16 Knurled Aluminum Free Float Forend

Diemaco / Colt Canada used to buy a LOT of stuff from PRI.
Gen III Rifle Length Round Forearms

Precision Reflex - Product Detail - Recce Rail In Flat Dark Earth - $150.00


Request Rejected
you can just see the rear seating point (ring on barrel above bipod) of the surpressor barrel sleeve in your photo with the can removed.
Reflex Suppressor for M16

[Brian Dick]

That figures. They have their fingers into everything. God forbid we want to do business! Many of the ITAR laws are so complicated and outdated. There are good folks trying to get some good changes made but the Department of Commerce is ill prepared to take on the extra duty. Maybe someday!

[Molonlave]

Thanks to all who have responded so far, much appreciated!

[Molonlave]

I've collected most of the parts I'm looking for. Seems that I read somewhere that a 2 stage trigger was used. Does anyone happen to know which brand?

[Lee Enfield]

I've collected most of the parts I'm looking for. Seems that I read somewhere that a 2 stage trigger was used. Does anyone happen to know which brand?

supposed to be KAC

[Molonlave]

Thanks for the helpful info!

[AL1EN]

So what barrel profile do think the C7CT uses?

[Molonlave]

From what I've been able to find, it appears the barrel profile is 20" heavy.

---------- Post added at 04:57 PM ---------- Previous post was at 04:54 PM ----------

Looking for info about scopes used on the C7CT. From a few photos, it looks like the Leupold 3.5-10x40 may have been used. Does anyone have any specifics? Reticle? Other brands?

[Rebel Rouser]