-
Advisory Panel
Originally Posted by
Mk VII
Some of the current rear h/g repros are rather tall
I'd put it in place and if it's too tall just sand it down carefully so as not to go into the rivets. Problem then is it'll be glassy smooth...
-
-
02-27-2019 09:50 AM
# ADS
Friends and Sponsors
-
Deceased August 31st, 2020
If it is bare wood, wet it. Water will raise the grain.
If it has a finish, steam it over the tea kettle spout.
It wont be glassy smooth anymore.
-
-
-
Legacy Member
And they just keep showing up. The rear was cracked, but it is already glued and clamped.
As always, curious about the markings.
-