Need the back 4 parts to complete my Danzing I.G. Mod. 71
Thanks!Information
![]()
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.
Need the back 4 parts to complete my Danzing I.G. Mod. 71
Thanks!Information
![]()
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.
I am looking for the correct sling for a civilian EAL rifle. If you have one you don't want please let me know. Thanks.
To the best of my knowledge they were not sold with a sling....
Looking for , to buy or trade , # 533 floorplate and rod .
I have a few specific gew98 part needs , some screws, couple of rods etc etc. Have a wad of gew98 parts on hand for swap on same. Drop me a line and I will email you my itemized by part type and their serials.
I don't sell my parts so please don't ask.
Seeking the top half of a WW1 german Kar98a trench cover. I have a bottom end clamp , just not the elusive top end. It is similar to the gew98 top cover , but slightly smaller dimensionally.
You got me over a barrel - help !.
Looking for any parts for my project. I have the barrel and bolt assembly, Stock and trigger guard. Need everything else... Let me know if you have any parts I could use.
Thanks
Haz
1901 Carl Gustafs needing rear barrel band, bolt release and floorplate marked 814 or not marked at all.
Looking for the following parts
K98
stamped floorplate marked byf and/or 135 code. Ser # only if 8249
Stamped t guard marked as above
Unmarked stamped barrel bands without screw hole drilled in them
rear site barrel sleeve (sweats onto the barrel) marked a 18 (bcd rifle)
Non-serialed cocking piece
Non-serialed bolt shroud
In my dreams - SS marked stock (has skull/crossbones forward of pistol grip even if cut down.
71 Mauser Carbine
Front band/sight guard and screw
piece that is sweated onto end of barrel for above to screw through
Front swivel (it is a ring)
Stock or cut off front end of stock
Extractor
flip site for rear site
rear swivel
If you have a rusted out junker with above, will buy it.
KAR 88
Front site protector/band
Have trade goods, especially K98
Looking for full length barrel & wood, Mk*III Ross
Last edited by bushwhacker; 06-08-2008 at 05:08 PM.