Ammo question

[Dave Waits]

Gunner, check your case-length and then take a thin 6" steel rule and slide it along the side of the chamber til it stops.Use thepoint where your longest round ends(Face of the casehead as the other end and compare. Remember, 45ACP headspaces on the casemouth. Sounds like you're running into a headspace problem with your oal.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[gunner]

Thanks DaveHH, i`ll test it. I have a bit of Bullseye.

Regards

Gunner

[gunner]

Hi Dave i`ll go to load a few rounds for tomorrow and i`ll check it, thank you.

Regards

Gunner

[gunner]

Dave, thank you for this advice it hits the point exactly. Today i testet it and now this pistol shoot much better. The rest is my own accuracy problem.

Regards

Gunner

[TDH]

5.5 grains of WW 231 pushing anything between 185 and 230 in most configurations,I say most because we have a 230 grain flat nose that sometimes causes feed problems. And the Lee factory sizing die is a must.