Correct Striker Protrusion Gauge

**pcaru1** · 03-26-2011 11:47 AM

I just took a Mosin tool and ground it flat to have an accurate base and then ground in the appropriate depth notches. Stamped basic numbers to ID each slot. Pretty easy and seems to work just fine.

**Highly Recommended** · 03-26-2011 11:47 AM

A Collector's View - The SMLE Short Magazine Lee Enfield 1903-1989. It is 300 8.5x11 inch pages with 1,000+ photo’s, most in color, and each book is serial-numbered. Covering the SMLE from 1903 to the end of production in India in 1989 it looks at how each model differs and manufacturer differences from a collecting point of view along with the major accessories that could be attached to the rifle. For the record this is not a moneymaker, I hope just to break even, eventually, at $80/book plus shipping. In the USA shipping is $5.00 for media mail. I will accept PayPal, Zelle, MO and good old checks (and cash if you want to stop by for a tour!). CLICK BANNER to send me a PM for International pricing and shipping.

Manufacturer of various vintage rifle scopes for the 1903 such as our M73G4 (reproduction of the Weaver 330C) and Malcolm 8X Gen II (Unertl reproduction). Several of our scopes are used in the CMP Vintage Sniper competition on top of 1903 rifles.

Brian Dick ... BDL Ltd. - Specializing in British and Commonwealth weapons

Specializing in premium ammunition and reloading components.

Your source for the finest in High Power Competition Gear.

Here at T-bones Shipwrighting we specialise in vintage service rifle: re-barrelling, bedding, repairs, modifications and accurizing. We also provide importation services for firearms, parts and weapons, for both private or commercial businesses.

**burgie** · 03-26-2011 11:51 AM

Yes I had read many a sad story of how guys bought a tool and sheared off the tangs the first time they used it. The guys on the forum wrote to soak the bolt in paint thinner overnight then give the tool a try. After ordering a firing pin tool from Gun Parts and paying $10.00 plus shipping I did just that and am happy to say my tool is still intact.

**ickmann** · 03-27-2011 09:45 PM

Its the combination tool that I'm looking to try a hand at reproducing although the firing pin removal tool looks a bit easier to fabricate. A lot less cutting and shaping. I guess a simple piece of flat stock with the appropriate depth of notches would be the easiest way to go. I think I have seen something like that while searching for a combo tool.

Ian

Thread: Correct Striker Protrusion Gauge

Thread Tools

Search Thread

Display

Bought a firing pin tool just like the one sold by Alan

Similar Threads

No4 Mk1 Firing pin Protrusion

Check out this Gal shooting 20 gauge ammo out of a 12 gauge shotgun

Striker Protrusion

Striker

ordered 30 06 go gauge and no go gauge

Tags for this Thread

Posting Permissions