-
-
-
04-21-2011 08:00 PM
# ADS
Friends and Sponsors
-
Legacy Member
The trick in all this "old stuff" is that the method of production was essentially unchanged from the mid 19th century.
There was no multi-axis CNC capability, hence almost every cut was made on a dedicated machine set up for that particular process. Hence one of the most fascinating documents to get your paws on is a "process book".
As an example, the bolt for an M-1 Garand rifle had over 80 separate "processes" from initial forging to surface coating. Almost every one of these was done on a separate machine or bank of machines.
Each process also had a set of "Go-No Go" gauges, so the amount of gauging and tooling for an entire rifle was immense. Check out the photo of components and gauging in Ian Skennerton's book for an idea of the scale of work involved.
Changing from a Mk1 to a Mk4 body was feasible, but would have required a lot of new fixtures, tools and gauges.
-
Thank You to Bruce_in_Oz For This Useful Post:
-
-
Many shooters seem to think that the trigger block that converts a Mk1 or 1/1 to a Mk1/2 or 1/3 is pre machined and brazed on. NOT SO. It was brazed on as a solid block then machined in situ. All measurements were subsequently taken from the sear axis pin hole and angles from the lower face of the body
-
The Following 5 Members Say Thank You to Peter Laidler For This Useful Post:
-
FREE MEMBER
NO Posting or PM's Allowed
That makes sense. A finished part could shift slightly while being brazed onto the action body.
-
Legacy Member
I recently got a mk2 forend with multiple FR steps as well as what I think are lamda stamps. There is also a P over 5P just below the metal nose cap.
-