Remington 03A3 front sight blade dilemma!

[warning5]

Try a carbide end mill in a hand drill . Take your time it will work.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Rocklobster]

Thanks for all the helpful ideas. Mike D, your starter punch suggestion was the ticket. First, I chucked the pin punch into my cordless drill and used a file to turn it down to .055". Then I heated the sight block with a propane torch and gave the pin a healthy SCHMACK with the solid punch, which loosened it enough to complete the task with the pin punch.

Thanks, again!