Springfield Armory M1A with Sage EBR

[USMC6094]

How do you like the Larue cantilever mount? I'm looking into getting one for my own M1A EBR build.

[Bizio]

How do you like the Larue cantilever mount? I'm looking into getting one for my own M1A EBR build.

Hello USMC6094,

as I said I had no time to test the rifle yet.
I read anyway lots of impressions over the internet about the LaRue mount and the Sage Cantilever mount.
It seems that the latter is free from any vibration because it is also supported on the back, over the block at the sights while the LaRue might have some vibrations since it is a pure cantilever mount. The Sage is not available at the moment up to end of summer 2012 and this is the reason why I took the LaRue mount.
I think the problem can occur in fully automatic rifles where the rounds frequency is high and the mount can vibrate slightly, so I will never experience this problem, in Italy we can only have semi auto rifles.

[USMC6094]

Bizio
I've looked at both and only the Larue is in stock and ready to ship. I've also looked at two other mounts, one Larue and the other American Defense. All three dont have the rear securing screw of the SAGE mount.
Heres the Larue mount I'm looking at.......

[Bizio]

Hi USMC6094
it seems a good mount.
I preferred the LT608 because while shooting on short distances I remove the Nightforce scope and I replace it with EOTech 557 with its Magnifier, so I need the Picatinny rail anyway.

[USMC6094]

Ahh gotcha. Well I look forward to your range report with great anticipation

[Bizio]

Certainly will do !

[USMC6094]

Any luck , I havent made it to the range in almost three weeks

[Bizio]

Same here, no chance yet to test the rifle, the weather has been always horrible during all week ends