New GEW rifle

[browningautorifle]

I wouldn't know how to post them to save my life

You could Email them to me and I'll post them for you...

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[hammer62]

You could Email them to me and I'll post them for you...

I tried to send you an email with pic....could not figure out how to add the attachment......excuse my ineptitude

[majspud]

Not seeing the pics...

T

[browningautorifle]

Not seeing the pics...

There aren't any...at this point.

[browningautorifle]

Check your PMs...

[browningautorifle]

Here's Hammer62's pics for you guys to check out...

[WarPig1976]

Thank the good Lord, not Bubba goo!!!. Looks to be a legit aged oil finish OR BLO from the receiver ring closeup. I like the look,,color and all,,if it where me I'd leave it but hey it's a free country...

[browningautorifle]

I'd probably leave it alone too.

[hammer62]

The pictures don't do the sheen justice. It is very glossy. I was just looking for some re-assurance either way on what to do with it before I acted either way. Thanks guys for all your suggestions, I'm still on the fence. But alot of good suggestions

[Patrick Chadwick]

Hmmmm????

The receiver ring looks rather too shiny to have just been covered with linseed oil. The original metal surface becomes increasingly dull - even rusty - with age. It does not become shinier! There is something on top of the metal. It could indeed be some kind of varnish. I have seen several old rifles that were varnished, and in many cases, removing the varnish showed up a much better looking surface underneath. However, it is necessary to proceed carefully...

1) You will have to remove the barrelled action from the stock.
2) Does the shiny surface of the wood go round the top of the stock into the barrel channel or handguard? If so, then the stock was "painted" - but with what?
3) Caution - irreversible action! Try dabbing and rubbing a test area inside the barrel channel or handguard with a cloth well-wetted with turpentine.
4) If the turpentine soaks into the test area and you can feel it rubbing on the wood fibres, indicating that the surface finish is being softened, then it is a linseed oil finish. Proceed as described in my previous post.
5) If the turpentine just swims on the top and the cloth just slides around with practically no friction, i.e. no softening, then you have a "treacle rifle".

- Do not be disheartened! For "before" and "after pics of a treacle rifle, go here:
https://www.milsurps.com/showthread....=treacle+rifle
and here
https://www.milsurps.com/showthread....=treacle+rifle

Whereby you will discover just what I mean by a treacle rifle. And how to deal with it!