thanks gentlemen. the level of knowledge here never ceases to amaze.
i think my fakie will get a grooved hand guard as i love the way they look. good thing i'm not in a hurry, finding a good late '44 shirley receiver, to match my scope, might take some time over here.
was there a standard for cutting the grooves?
i couldn't see it in the Knowledge Libraryarticle.
aka were the grooves all the same length?
were they cut with the bottom face in the same plane as the bottom of the hand guard or were they a V where the centre line of the V is at right angles to the face?Information
![]()
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.