M1 Carbine Stocks

[JimF4M1s (Deceased)]

I would consider finding another reference choice and compare it to that acrylic page from the Harrison book.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[imntxs554]

I was just looking at it more and there something that looks like it could of been a box " _| " with looks like a J N and i was using a Magnifying Glass and that is all, but i think there's not enougn to add. The Stock fits very Well and I have a few Handguards and one almost matched it, but its about as good as its going to get. I wish i had more to give you guys. This was something i just wish i knew. Thanks for all the help. Y. R.Y. O. B. I want to say Hi to all from the Pistol and Rifle Club who joined. It gets Better You will get lots of help and Be Patience. There are some great guys Here that Will help, Just Ask.

Frank

[painter777]

On that Trimble stock,
Does the CC look to be the size of a Inland stamp?

Asking, Because it looks like it may have a sideways I stamped in the slingwell below the TRIMBLE TN marking.
If so, very possible it could be a cross support stock.

Cheers,
Charlie-Painter777

[imntxs554]

Painter, On the Trimble over TN has that line and comparing it to my other Inland Stock the CC is the same size. Cross Support Stock ?

Frank

[painter777]

Here's a old link with some mention of Trimble TN stocks going to Inland:

Trimble Tn Stock For Inland ?

HTH,
Charlie-Painter777