-
FREE MEMBER
NO Posting or PM's Allowed
K31 action screws
I bought a new to me K31 last week. When I tighten the action screws the floor plate is loose at the tang. I tightened the receiver screw first and then the tang screw. Is this normal?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
05-17-2010 01:52 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
There are some good articles here on stock fitting, bolt tightening and using different thickness plates.
The Swiss Rifles Message Board - Message Board Yuku
-