-
Legacy Member
Piston post interchange Mk.I and Mk.II
Need some advice on a Bren No.I build . Are the piston posts from a Mk.I and Mk.II interchangeable and can be used on a extension that came with my Mk.I parts that was missing the post ? Will I need anything beside the Mk.II post ,springs ect.if they are interchangeable ?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
01-08-2019 10:58 AM
# ADS
Friends and Sponsors
-
You use a Mk1 p-post with a Mk1 spring and plunger and a Mk2 with Mk2. If my old memory serves me right, the long Mk1 plunger bottoms out in the Mk2 post (or vice verca, sorry) and once the spring end of the plunger mushrooms out, it's a bugger - or almost impossible - to separate them. Spring or no spring!
-
Thank You to Peter Laidler For This Useful Post:
-
-
Legacy Member
Peter my piston post hole is 3 1/4'' deep the step for the spring is 2 1/8'' . The post is 3'' long and the spring is 3 1/4'' long . Can you tell from these measurements what I have . Thanks .
-