-
Legacy Member
Hm..is this normal?
Picked up a No 5 (?) Remington Rolling Block over the weekend in 7mm SM. I'm sure it saw South American use, no serial numbers, pitting on the barrel. Anyway, got the forestock off, and found this 'hole' drilled on the underside of the barrel. Its not all the way through, is this supposed to be here?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
Thank You to Anzac15 For This Useful Post:
-
06-19-2018 10:40 AM
# ADS
Friends and Sponsors
-
Legacy Member
I have a Remington Rolling Block barrel from a Model 1902 in 7mm (7x57mm) and the barrel has the same blind hole
-
Thank You to RCS For This Useful Post:
-
-
Legacy Member
-
-
Contributing Member
Doesn't look deep enough to harm anything. Not as deep as a drill and tap.
-