-
Advisory Panel
No 5 Flash Hider Removal?
Which side do you punch the retaining pins out from, L to R or R to L?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-08-2016 06:46 PM
# ADS
Friends and Sponsors
-
Can't remember but it's been answered on here a hundred times before together with details of the nickel press tool insert used to press the barrel off.
-
-
-
Legacy Member
Mine are Left to Right. The left ends of the pins are approximately 0.122” and the right ends about 0.139”.
Use a press to get the pins out, not a punch. A press less likely to damage the pins or the flash hider and you’re going to need a press anyway to get the flash hider off.
-
The Following 3 Members Say Thank You to Vincent For This Useful Post:
-
On the topic of these pins, does anyone know where i can get a few. They are usually 4-0 & are sometimes 3-0 presumably when they've come off and been reinstalled. Im not keen on buying the 1000 id need to from a commercial supplier.
-
-
Legacy Member
They are easy to make from drill stock steel. You can use the poor man’s lathe method if you don’t have access to a real lathe. All you need is a reversible high-speed drill and a sander. Put the drill in your vice and run it in reverse. Sand a little and check often. You will have them done in no time.
Don’t forget to use a tapered reamer if you’re cutting new grooves in the barrel. If you don’t have the taper reamer, the poor man’s way is to use 3 or 4 drill bits, decreasing in size to make “steps.”
-