-
FREE MEMBER
NO Posting or PM's Allowed
Remington buttplate ID
Hi guys, anyone able to ID this Remington buttplate? It's aluminum, slightly curved, and approximately 1/4" thick. Thanks in advance. Steve
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
05-21-2009 06:23 PM
# ADS
Friends and Sponsors
-
Legacy Member
Remington used AL buttplates from the 40's at least, through the 50's into the 60's. I cannot tell from your pic what firearm it might fit. They were used on 22's through 12 ga.
HTH,
Emri
-
Thank You to Emri For This Useful Post:
-
-
FREE MEMBER
NO Posting or PM's Allowed
It appears close to the one on my 1963 700BDL with the exception of the serrations on yours is diamond knurled on mine. The logo block, shape and thickness is the same. Good Luck.