-
FREE MEMBER
NO Posting or PM's Allowed
7.62x51mm NATO question
Hi everyone,
While reading Collector Grade Books monster volume on the FAL, I saw references to the T48 (the US FAL) being tested with 7.62x51mm API (amour piercing incendiary) rounds. I've never been able to find a US M-series designation for this round, so does anyone know what nation manufactured it and what the specs on it were?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
07-19-2014 06:39 PM
# ADS
Friends and Sponsors
-
Legacy Member
The US round was designated T101E1 the other was Belgium P186 as far as I know no other country made API rounds
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks! Anyone happen to know the specs on either round?
-
FREE MEMBER
NO Posting or PM's Allowed
-
Advisory Panel
-
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks, Tom, but what I'm looking for is something that states the type of powder and amount.
-
FREE MEMBER
NO Posting or PM's Allowed
along time ago, I bought some 30 cal., 150 grain (not 163gr. from 30-06) AP's that were pulled and I loaded them in 7.62x51 casings, which I shoot in my M1A. I used current load spec's from FMJ 150 loads.
They shoot just fine.
Chuck
-
Legacy Member
I don't think you will ever find the powder type or charge as Mil ammo manufacturers keep their brews close to there chests. I even wrote to ADI here in Aus to find the powder and charge for our 7.62 ball and was gently given 308 loads with a variety of powders.
-
-
Advisory Panel
The closest you can get is cartridges of the world publication has loads in the back for the military recipes. Then take the powder and ask around these forums what it is. Some are listed like IMR 4895, the rest are the hidden recipes. They are known though. The ammo you ask about likely wasn't released for consumption though.
-
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks for all the info guys!