Stock Question

[69 Stang]

Would a highwood oval cut stock be on a Inland in the 4.9 mill. serial range

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[usgicollector]

yes it could

[mar53]

Carbine club newsletter reports that High wood oval cut stock were reported up to about serial 4,935,xxx. After that high wood reported intermittently and less frequently than low wood. So I would read that to say around 4.935 was the cutover and some high wood ones continued to be used later in the block.