-
Dan Wilson
Guest
Strange problem (to me that is)
I had a strange problem on one of my rifles when I fired it for the first time, put in a fresh clip and it would short stroke and eat the fourth cartridge, none of the others, just the fourth.
Long story short it went away when I changed out the op rod catch, why would the op rod catch cause this?
Dan
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-07-2009 10:39 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
It's possible the accelerator pad was worn, and started to signal for an early clip latch release.
-
-
Dan Wilson
Guest
Only thing is the clip itself never released, it would just eat that fourth round, and shoot the other seven just fine - crazy
Dan
-
-
Legacy Member
Have you tried reversing the stack? IE top round on the left?
M1 user
NRA Patron Member
Land Cruiser fan
-
-
FREE MEMBER
NO Posting or PM's Allowed
![Quote](images/tacticalgamer/misc/quote_icon.png)
Originally Posted by
Dan Wilson
Only thing is the clip itself never released, it would just eat that fourth round, and shoot the other seven just fine - crazy
Dan
A lot of weird thing go on in there during the feed cycle. Remember the "7th round jam"? Just because a guide rib was nicked. Reverse the clip from top round right to top round left and the problem went away. The nick never bothered the 1st 6 rounds. Same instance here. The op rod catch didn't have to totally release the clip latch, just move it enough to alter the geometry. Or other such mysterious voodoo.
Had a case once where a rifle would not fire. Could not pull the trigger. Pulled back the op rod, ejected the round. Rifle would fire. Rifle would fire a couple more times, then, back to the problem. You could not pull the trigger. Drove me nuts. Finally, with the trigger group out, I began thumbing the hammer back over the trigger sear and pulling the trigger. Kept doing this over and over, and at times, the trigger again could not be pulled. Then I noted that the trigger pin was rotating. Pulled the pin out and found by rolling it between my thumb and forefinger, it had a slight bend in it. Replaced the pin and........no more problems.
-
Dan Wilson
Guest
Nope sure didnt.
Changing the op rod catch fixed the problem and now the rifles in others hands, thanks for the input though.
Dan
-
-
Dan Wilson
Guest
Yep, just like the fookin gremlins we used to have on the C-130 all the time![](https://www.milsurps.com/images/imported/2009/03/10171-1.gif)
Thanks Dan
Dan
-
-
FREE MEMBER
NO Posting or PM's Allowed
Now I like happy endings...Thanks Dan Shapiro for another lesson.![Thumbs Up](images/smilies/TUp.gif)
Semper Fi...