-
Legacy Member
Removal of 1903A3 front sight protector
How is one supposed to remove the darned thing?
CDD
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
04-18-2009 06:22 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
If you have one of the regular ones (non USMC) there are several methods. You can lift from the bottom of both sides while pulling out and away from the barrel, you can put a piece of stout cord through the top of the cover and pull it off that way, some folks pry from the front or the back. All of these methods will mar the barrel.
If your rifle has a USMC front sight cover you probably have a job for a gunsmith.
On M1903 rifles I just leave them on since they don't interfere much with the sight picture. On M1903A3s I remove them before shooting.
-
-
FREE MEMBER
NO Posting or PM's Allowed
I use 'the cord method' to pop mine off my shooter. The closet queens keep theirs on.
-
FREE MEMBER
NO Posting or PM's Allowed
Stick a screwdriver with a round bit through the sight hood, then get two fingers on either side of the sight hood and give a fast yank. This will do no more damage to the barrel than any other method and less than others.