-
Legacy Member
Krag Bolt Problem
I am running into a problem in my restoration project. I replaced a sporter barrel with a full length barrel. When I put in the bolt it will not quite go in all the way. It runs into something and looks like it needs a quarter inch or so to complete the rotation of the bolt. It worked fine with the old barrel an I am not sure if it did after the replacement. Could the new barrel be the problem or is something else preventing the full rotation?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
08-21-2013 09:01 PM
# ADS
Friends and Sponsors
-
Contributing Member
Does the new barrel have the extractor cut in it ???? When installed the cut should be at 12:00 o'clock.
-
-
-
Legacy Member
Yes, there is a notch but when I tightened the barrel to max using a proper wrench etc. it was about 1/16" short and the extractor won't go in. For now I rotated the barrel 360 deg. And the bolt will go in, but the barrel is not tight. I applied maximum force to the wrench. Should I try to file the notch to make it bigger?
-
-
FREE MEMBER
NO Posting or PM's Allowed
Strip the bolt and check the headspace and how does the front sight index?