-
FREE MEMBER
NO Posting or PM's Allowed
Is there any interest in 7.35 Carcano?
Hello,
I have recently perchased some reloading dies and components for the 7.35 Carcano. Is anyone else reloading for it? If so what are you doing for loads? Any suggestions? Also, would anyone be interested in buying components as a group to ave some money as it is expensive?
mdrim13
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-22-2012 01:48 AM
# ADS
Friends and Sponsors
-
Grafs, yes? I can't remember how many bullets I have left. We've been using the Hornady bullets with Prvi 6,5 brass.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Any load data? Im getting ready to make my first batch as soon as I get the components I ordered in the mail. Also where are you getting your components? Ive been looking around and there doesnt seem to be much out there.
mdrim13
-
Legacy Member
The bullets I got from Grafs. I've had my 7.35 a while and at the time I got it about the only source of brass was necking up and trimming 6.5x52 stuff. IIRC, Buffalo Arms has components as well. I've experienced some failure to feed issues with Hornady bullets, they're not as long as military bullets so the rounds will have a shorter OAL. I don't have one but I'd think the latest Hornady manual would have 7.35x51 Carcano data. I use the data included in the Lee die set.
-
-
FREE MEMBER
NO Posting or PM's Allowed
I do have the new hornaday book and the 7.35 carcano is not in there. I planned on using data from the lee die set. I have some original ammo and I planned on getting OAL from those. What do you think? Do you still have you 7.35? If not would you sell any spare components you have around?
Mdrim13
-
-
-
Hornady's super load development guy Dave Emary wrote the following article on the 7,35 (and "incidentally" the 6,5) .:
SHOOTING THE 6
Last edited by jmoore; 03-24-2012 at 04:11 PM.
-
Thank You to jmoore For This Useful Post: