-
FREE MEMBER
NO Posting or PM's Allowed
1903 Springfield Sporter
Okay, I know this is frowned upon, but I recently picked up a nice 03 that has been sporterized.
I have a nice original 1903 and a 1903A3 in original condition. This was such a good deal I could not pass on the rifle. The question I have is about the spacing of the screw holes already drilled into the receiver. I found a nice Redfield JR. mount to go on the rifle. The front spacing is correct but the rear screw is about a 1/32 off. The rear screw spacing needs to be about 1/32 inch shorter. I can't seem to find anything on the screw spacing of mounts that were made to fit the 03. Since the holes have already been drilled into the receiver I would like to mount a scope on it, but I do not want to drill any more holes. Anyone have any ideas? I am not interested in the S&K mount. Do Leupolds have the same screw spacing? I suppose I could use a dremel to oblong the rear screw hole in the mount if necessary.
Thanks
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by TCPatriot; 05-04-2015 at 09:25 PM.
-
05-04-2015 09:22 PM
# ADS
Friends and Sponsors
-
Advisory Panel
sounds like a Bueler mount was on it at some point
-
-