-
Legacy Member
Bren Gun, removing barrel nut plunger ?
How do you remove the Plunger retainer and it's spring for barrel nut on the Bren gun ?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
12-03-2018 11:57 PM
# ADS
Friends and Sponsors
-
Legacy Member
If I remember correctly, push back the lever plunger and then push up on the Mag well dust cover plunger. Careful it’s under spring pressure.
-
Thank You to Brit plumber For This Useful Post:
-
-
Legacy Member
Push the horizontal part back until the verticle part launches itself off to no mans land
-
-
Legacy Member
Question when I push the horizontal pin as far back as it will go the mag. ball detent for the dust cover still will not raise up ? Is there something I am missing in the way I am doing it ?
-
-
Legacy Member
OK, I got it to pop up and out ,it needed a push up from the bottom more than I though . I see how the mag.cover
detent is made with a off set cut that needs to be in the right position to allow it to move up and out. Thank you all for the much needed help .
-