-
Legacy Member
LEE ENFIELD HT SNIPER SIGHT
HI
looking for some info on the markings on this no1 mk3 rear sight.
Have been told the T means it is for Lithgow HT sniper heavy barrel
but the inside diameter is the same as normal no1 mk3 rear sight,
should it be bigger if meant for heavy barrel.
Any help would be much appreciated
thanks
deanb
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
07-11-2017 08:51 AM
# ADS
Friends and Sponsors
-
I'm afraid you've been misinformed. The early sight bases had a transverse locating pin that was tapered, not parallel sided, as in the later bases. The 'T' just means that the hole by it is for a tapered pin (ie the pin will only go in one way).
And yes, the H barrel is of a greater diameter so the bases had to be reamed out to accommodate it.
Hope this helps a little.
-
The Following 4 Members Say Thank You to Roger Payne For This Useful Post:
-
-
Legacy Member
Roger
thanks for the help that's cleared that one up.
-
Thank You to deanb For This Useful Post: