-
FREE MEMBER
NO Posting or PM's Allowed
7.7x58 will not chamber?
i got a arisaka 99 that has tha mum stamp,nagoya,,,but 7.7x58 will not chamber,,,a 303 will go in about 2/3 tha way,,,,it has only 1 gas relief hole below tha mum,,,tyvm,,,
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by Badger; 01-12-2017 at 06:08 AM.
-
01-11-2017 11:36 PM
# ADS
Friends and Sponsors
-
Advisory Panel
Unless there is an obstruction in the chamber, perhaps it has been converted to another caliber.
Chinese conversion to 8x57 or 7.62x39? Korean to .30-06? A chamber cast might be appropriate.
-
Thank You to tiriaq For This Useful Post:
-
-
Legacy Member
Did you load the round in the magazine and then close the bolt? The Type 99 has a mauser type extractor. This means you can not just drop a round in the chamber because the extractor cannot snap around the cartridge rim. The cartridges need to be loaded from the magazine.
If it does not work by loading from the magazine, suspect that the barrel has been converted to a new caliber.
I apologize if this response seems too basic, but I don't know your level of expertise.
Walter
-
Thank You to WNO1958 For This Useful Post:
-
Legacy Member
More than a few converted to .300 Savage out there.
Al
“Any society that would give up a little liberty to gain a little security will deserve neither and lose both.”- Benjamin Franklin
-
Thank You to Al Diehl For This Useful Post:
-
Advisory Panel
Welcome to the forum, yes a chamber cast seems to be the way to go here...
-
Thank You to browningautorifle For This Useful Post:
-
Contributing Member
Welcome to Milsurps, as has been said by Jim and others the definitive answer will be gained by a chamber cast and slugging the bore.
-
-
Advisory Panel
Although it might not help either, we'd love to see pics of this one too...it might help... Mostly we just want to see.
-
-
Legacy Member
If it was rechambered to 30/06 , or 8mm a 7.7 will still chamber . If it was redone to 300 Savage the barrel shank will be shorter . If it has a non Japanese barrel on it you should be able to tell by looking at it .
-
-
Advisory Panel
Could also be a separated case in it, anything could be wrong. It needs a look see...
-
Thank You to browningautorifle For This Useful Post:
-
Mostly Type 38s that I've seen, but wondering if it wasn't converted to 7,62x39? The fact that .303 SAA fits relatively well but is short supports that guess.
-