-
FREE MEMBER
NO Posting or PM's Allowed
E marked trigger housing & LT-O Trigger ID
Hi guys greetings to everyone!! Just need some help in identifying my trigger housing it has an E marking under between the magazine release & safety...Also kindly id the trigger that has LT-O mark...TIA!!! Here is the picture below;
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
10-22-2011 03:19 PM
# ADS
Friends and Sponsors
-
Legacy Member
Look closer on the trigger, I think you will see that that is LT-Q, which would be Quality Hardware. As for the E on the housing - I dont know, probably an inspectors mark. Look on the left and right side at rear sides by the rear lug and see if you see a marking, or on the back of the magazine well. Underwood puts .U. in the magazine well.
Last edited by Rustship; 10-22-2011 at 03:44 PM.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Hi Rustship, here is another mark that I found on the right side, seems to be a sideways U, is that for Underwood? TIA guys...
-
FREE MEMBER
NO Posting or PM's Allowed
That is an early WRA housing.