-
FREE MEMBER
NO Posting or PM's Allowed
Parker Hale has lost accuracy
I have a PH .308 with a Mauser action,I think its a 1100 deluxe.
I used it the other day and the accuracy could have been a lot better.
On checking it out I found the screw in front of the magazine very loose.
Does anybody know how tight it should be as it pulls the barrel down?
Thanks
Tony
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
04-17-2017 05:41 AM
# ADS
Friends and Sponsors
-
Contributing Member
Tony,
Do it up as you would any screw and then a final half turn to crank it in place. There are no meter measurements for that. Only you will know what the thread is like, just be careful of overtightening as you could crack the stock.
'Tonight my men and I have been through hell and back again, but the look on your faces when we let you out of the hall - we'd do it all again tomorrow.' Major Chris Keeble's words to Goose Green villagers on 29th May 1982 - 2 PARA
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
thanks Gil I will give it a go
-
Advisory Panel
I've seen several of those shot loose. Once they do they'll beat themselves apart. Hopefully this is the issue with accuracy and not a worn bore?
-
-
FREE MEMBER
NO Posting or PM's Allowed
I have not measured the bore but it looks good
-
Advisory Panel
It's hard to say exactly about that. I had a Savage 110 that looked good but when shooting it would heat up and climb up off the target after a few rounds... Anyway, like stated, tighten things to tight and try again.
-