wanted 24volt slave cable

[Maple_Leaf_Eh]

I'm looking for a two-pin 24v slave cable for my M38A1 Jeep. Heavy and a bit like wrestling an annaconda snake. Hopefully in Canada or Eastern US.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Oscarflytyer]

I would bet that you would have better luck building your own... From what I recall, you will need to find the right terminal end receptacles. That may be the hardest part... good luck.

[Maple_Leaf_Eh]

You are all heart! I've seen them advertised for $150 to $200, and then there is shipping. I have a NSN, so some searches are easier. You are right about getting the ends right. Mine needs 2 prongs, and the more modern style uses a single plug with the ground on the outside edge of the coupling.

[IE_MACK]

i have one in good condition.its the 20' length too.165.00 plus shipping?

[Oscarflytyer]

You are all heart! I've seen them advertised for $150 to $200, and then there is shipping. I have a NSN, so some searches are easier. You are right about getting the ends right. Mine needs 2 prongs, and the more modern style uses a single plug with the ground on the outside edge of the coupling.

OK - don't think I have ever been accused of that! AND dang near spit my drink all over my pc when I read it! My point was, I figured it would be a bear to find one, at least relatively inexpensively. My thought was, IF you find the terminals, a cable w/ the correct number of, and wire size - then you can just pin it out. Built radio cables this way. Can be painful, but it works, and probably a lot less $$ than buying one.

Either way, I wish you the best of luck!