-
FREE MEMBER
NO Posting or PM's Allowed
Center aline rear adg. Sight
i have a inland that had a loose adj.rear sight that was loose i fixed by peening and put back on centered by re-aline bY using old stake marks.i have a auto ordnance that has a flip sight that i wan,t to put a kensight adj.sight on,how do i make sure i have the sight centered .thanks
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
07-27-2011 06:47 PM
# ADS
Friends and Sponsors
-
Legacy Member
-
-
-
If the AO is sighted in correctly for windage, I would use a dial caliper to measure the width of the flip sight, width of receiver dovetail, and the amount the sight is offset from center, if any. Then measure the width of the new adjustable sight and calculate the amount of offset it would need in order to have the aperature in the same relative position as on the flip sight. - Bob
-